-40%
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90
DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90

DAREX PRECISION END MILL SHARPENER w/ 5C COLLET AIR SPINDLE - #E-90

$ 633.59

Availability: 100 in stock
  • Country/Region of Manufacture: United States
  • Brand: Darex
  • Model: E-90
  • Condition: This is a Precision Endmill Sharpener w/ 5C Air Spindle. There are a couple things that need to be noted, there is a small crack on the rear of the motor housing as can be seen in the last picture, also when powering on the unit there is a bit of a screech that comes from the wheel spindle, sounds like the bearings might be dry, but I cannot say for sure what the issue is. Other than that, the unit appears fine and was in operation when we acquired it. Thank you.
  • All returns accepted: ReturnsNotAccepted

    Description

    Made in the USA by Darex Corp.
    This is a Precision Endmill Sharpener w/ 5C Air Spindle. There are a couple things that need to be noted, there is a small crack on the rear of the motor housing as can be seen in the last picture, also when powering on the unit there is a bit of a screech that comes from the wheel spindle, sounds like the bearings might be dry, but I cannot say for sure what the issue is. Other than that, the unit appears fine and was in operation when we acquired it. Thank you.
    Model #: E-90
    Serial #: 92308
    SPECIFICATIONS:
    Spindle Taper: 5C
    Cutter Diameter Range: 1/16" to 2"
    Shank Diameter Range: 3/16" to 1"
    Motor: 1/4 Horsepower, 115 Volt, 3.2 Amp, 2,800 / 3,400 RPM, 50/60 Hz, Single Phase
    Electrical: 115 Volt, Single Phase
    Overall Dimensions: 22" x 18" x 11" high
    Comes exactly as shown in pictures.
    LOCAL PICKUP AVAILABLE @ 1520-A INDUSTRIAL PARK ST. COVINA, CA 91722.
    HABLAMOS ESPAÑOL.