14" X 72" LANDIS 3RH UNIVERSAL CYLINDRICAL GRINDER, HYD. INFEED, 14" WHEEL, 1977

Description

WISCONSIN METALWORKING MACHINERY
ID#9876
Specifications:
GENERAL SPECIFICATIONS:
Swing Over Table............................ 14-31/32"
Maximum Distance Between Centers............ 72"
Grinding Wheel Size......................... 14" x 1-1/2" x 5" Bore
Grinding Wheel swivel range
upper.................................... 180 degree
lower.................................... 60 deg cw - ccw
Grinding wheel spindle speeds............... 1720 - 2185
Automatic infeed at table reversal-on dia.
machine with hydraulic infeed............ .0002" to .004"
Rapid infeed stroke......................... 1.5"
Headstock work center....................... 14 jarno
Footstock work center....................... 10 jarno
Wheelhead motor............................. 5 hp
Swivel table inches per foot................ 3"
Swivel table degrees included angle......... 14 degrees
Wheelhead Swivel............................ Up to 90 Degrees and is Repositionable on a Secondary Slide
Variable table traverse speed............... 2 to 240 IPM
Work drive motor............................ 1 hp
Work speeds infinitely variable
low range................................ 12 to 72 rpm
high range............................... 60 to 360 rpm
Hole thru headstock spindle................. 1-7/16"
Headstock swivel range...................... 120 degree
Headstock spindle nose...................... 6a-2
Floor space................................. 74" x 229"
Machine weight.............................. 12,500 lbs
EQUIPPED WITH:
Wheelhead Can Be Setup for Compound Angles or Steep Angle Without
Dressing an Angle on the Grinding Wheel
Live and Dead Spindle Type Workhead
preloaded ball sleeve footstock with quick acting lever control
rapid advance and retraction of grinding wheel
traverse or plunge grinding
cushioned reversal while traverse grinding
independent tarry controls for each end of traverse
isolated hydraulic reservoir for minimal heat transfer
SPECIFICATION SUBJECT TO VERIFICATION
CONDITIONS OF SALE
TERMS
:
Cash or check with order, unless otherwise stated.
WARRANTY:
The goods described herein are pre-owned used goods and are offered "as is", "where is" unless otherwise noted herein, SELLER MAKES NO WARRANTIES OF ANY KIND WHATEVER, EXPRESSED OR IMPLIED, OR MERCHANT-ABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  All specifications and description of said goods are approximate only.  It is the Buyers responsibility to inspect the goods and ascertain if the specifications, description and condition of the goods conform to Buyer's requirements.
MACHINE USE AND SAFETY:
Buyer acknowledges that the goods described herein are preowned used GOODS WHICH WERE NEITHER DESIGNED NOR MANUFACTURED BY THE seller, nor has the Seller knowledge of,  or control over the prior use or misuse of said goods, nor does the Seller have knowledge or control over the future application of these goods by the Buyer.  It is the Buyer's (user's) responsibility to provide proper safety devices, equipment and instructions for any particular use and to take all necessary steps to conform to all federal, state or local government safety standards including OSHA.
INDEMNIFICATION:
Buyer agrees to indemnify, hold harmless and defend Seller of and from any and all claims, liabilities and damages from any accidents or other incidents involving the goods described herein.